Port hardstanding — Hull docks
Bulk capping and sub-base supplied by artic with controlled vehicle movements inside the port estate.
Yorkshire & the Humber
Muckaway & Soil Removal in Hull
Atlas Stone Supplies removes surplus dig, subsoil, clay, hardcore and made ground from sites across Hull and the wider Yorkshire & the Humber area. We classify the material where the disposal route isn't already confirmed, book the right vehicle for your access, and back-load aggregate on the return leg so you pay for one movement instead of two.
Hull site conditions we plan around
Low-lying ground and port-side hardstanding mean capping and free-draining granular fill are core, with artic tonnage for the larger energy and logistics platforms.
Lead times & access
Tipper, grab and artic loads across Hull, Beverley, Goole and Grimsby, typically within 24–72 hours on stocked lines.
What we handle on Hull muckaway jobs
- Surplus subsoil, clay and topsoil from bulk excavation and reduced-level dig
- Hardcore, crushed concrete and demolition arisings
- Made ground and mixed muck from brownfield and infill plots
- Trench arisings from drainage and utility runs
- Contaminated soil, once classified, routed to a licensed facility
Options for Hull sites
8-wheel tipper
Around 16–20 tonnes per load — the standard workhorse for open sites with room to reverse and tip.
6-wheel tipper
Lighter and shorter for restricted estate roads, narrow accesses and weight-limited routes.
Grab lorry
Loads itself from a stockpile or verge with an extended-reach arm — no excavator needed on site.
Artic bulk
Highest tonnage per movement for volume earthworks where access and hardstanding allow.
How it works
01
Tell us the material and access
Material type, rough volume, site postcode and how a lorry gets in and out.
02
We confirm the route
Classification if needed, then the licensed disposal or recovery facility and the vehicle that suits your access.
03
Loads run to programme
Phased to your dig rate, with duty-of-care transfer notes issued for every load.
Compliance and paperwork
All haulage runs under registered waste-carrier licences, with duty-of-care transfer notes for every load and WAC/WM3 documentation where the material requires classification.
Our credentialsRecent work around Hull
Housing regeneration — west Hull
Sub-base, bedding and topsoil supplied on a phased call-off across a demolition-and-rebuild programme.
Muckaway — Goole
Wet clay arisings removed by tipper after classification, with granular fill returning on the back load.
Areas covered from our Hull routes
- Beverley
- Goole
- Grimsby
- Bridlington
- Scunthorpe
- Withernsea
Muckaway in Hull — FAQs
How quickly can you start a muckaway in Hull?
Where the material is already classified, Hull sites can normally be mobilised within a few working days. If WAC testing is needed first, allow time for sampling and lab turnaround before the first lorry moves.
Can you take muck away and deliver aggregate on the same visit?
Yes — two-way loads are the default on Yorkshire & the Humber jobs. The lorry tips your arisings at the facility and returns loaded with Type 1, capping or bedding stone, which cuts both vehicle movements and cost.
Do I get duty-of-care paperwork?
Yes. Every load leaves with a waste transfer note recording the carrier, the waste description and the receiving facility, so your site file stays compliant.
What if the soil turns out to be contaminated?
We sample to BS EN 14899, run UKAS WAC analysis and issue a WM3 hazard assessment, then route the material to a facility licensed to accept it. Nothing moves before the route is confirmed.
Need muckaway in Hull?
Tell us the material, volume and access — we come back within one working day.