Muckaway & Soil Removal in Cambridge
Atlas Stone Supplies removes surplus dig, subsoil, clay, hardcore and made ground from sites across Cambridge and the wider East of England area. We classify the material where the disposal route isn't already confirmed, book the right vehicle for your access, and back-load aggregate on the return leg so you pay for one movement instead of two.
Cambridge site conditions we plan around
Conservation-area access and college estates mean timed, low-disruption drops; the science-park and biomedical campus pipeline runs on bulk sub-base and drainage bedding.
Lead times & access
Grab, tipper and HIAB loads across Cambridge, Ely, Huntingdon and Newmarket. Timed and out-of-hours windows for city-centre and campus sites.
What we handle on Cambridge muckaway jobs
- Surplus subsoil, clay and topsoil from bulk excavation and reduced-level dig
- Hardcore, crushed concrete and demolition arisings
- Made ground and mixed muck from brownfield and infill plots
- Trench arisings from drainage and utility runs
- Contaminated soil, once classified, routed to a licensed facility
Options for Cambridge sites
8-wheel tipper
Around 16–20 tonnes per load — the standard workhorse for open sites with room to reverse and tip.
6-wheel tipper
Lighter and shorter for restricted estate roads, narrow accesses and weight-limited routes.
Grab lorry
Loads itself from a stockpile or verge with an extended-reach arm — no excavator needed on site.
Artic bulk
Highest tonnage per movement for volume earthworks where access and hardstanding allow.
How it works
Tell us the material and access
Material type, rough volume, site postcode and how a lorry gets in and out.
We confirm the route
Classification if needed, then the licensed disposal or recovery facility and the vehicle that suits your access.
Loads run to programme
Phased to your dig rate, with duty-of-care transfer notes issued for every load.
Compliance and paperwork
All haulage runs under registered waste-carrier licences, with duty-of-care transfer notes for every load and WAC/WM3 documentation where the material requires classification.
Our credentialsWhat shapes muckaway in Cambridge
Most Cambridge muckaway we plan involves arisings off tightly controlled campus and college sites, so the disposal route is settled before the first lorry is booked rather than after a load is turned away. Conservation-area and college-estate drops needing timed, low-disruption windows decide whether the job runs on tippers, grabs or a mix of both. The same routes reach Ely, Huntingdon and St Neots, and where aggregate is going back in we load the return leg instead of running the lorry out empty.
Areas covered from our Cambridge routes
- Ely
- Huntingdon
- St Neots
- Newmarket
- Royston
- St Ives
Muckaway in Cambridge — FAQs
How quickly can you start a muckaway in Cambridge?
Where the material is already classified, Cambridge sites can normally be mobilised within a few working days. If WAC testing is needed first, allow time for sampling and lab turnaround before the first lorry moves.
Can you take muck away and deliver aggregate on the same visit?
Yes — two-way loads are the default on East of England jobs. The lorry tips your arisings at the facility and returns loaded with Type 1, capping or bedding stone, which cuts both vehicle movements and cost.
Do I get duty-of-care paperwork?
Yes. Every load leaves with a waste transfer note recording the carrier, the waste description and the receiving facility, so your site file stays compliant.
What if the soil turns out to be contaminated?
We sample to BS EN 14899, run UKAS WAC analysis and issue a WM3 hazard assessment, then route the material to a facility licensed to accept it. Nothing moves before the route is confirmed.
Can you deliver into conservation-area streets?
Yes — HIAB, bulk bags and manual offload cover sites where a tipper cannot discharge, with timed windows to limit disruption.
Need muckaway in Cambridge?
Tell us the material, volume and access — we come back within one working day.